Ursprungligen postat av
bogieboy
Hej provflög min funcub idag men det gick inte så bra! Motorn lossnade i luften fäste släppte (Men den klarade sig bra trots allt) så nu ska jag försöka göra ett nytt fäste någon som har lite mått och vinklar på hur motorn ska sitta?
Lite info här, sidan 11:
http://www.multiplexusa.com/files/FunCubManual.pdf
" 20. Attaching the motor bulkhead to the motor mountThe motor sidethrust and downthrust can be adjusted inconjunction with the motor mounts
37 and the motor bulkhead
38
. The motor mounts are installed asymmetrically asstandard: when the four adjustment screws 39 are set flush,the motor is positioned with maximum possible sidethrustand no downthrust, which is our recommended basic setting.These settings apply when looking at the motor bulkhead fromthe tail.
Fig. 28
The grubscrews should project from the rear of the motorbulkhead by the amounts stated below:Upper left: 3.0 mmUpper right: 3.0 mmLower left: 1.5 mmLower right: 1.5 mmThe screws should project by the stated values.
You will need to make minor adjustments during test-flying!"