Reklam

 
Resultat 1 till 3 av 3

Ämne: Byron Glasair.

  1. #1


    Reg.datum
    aug 2009
    Inlägg
    11
    Jobb
    Cnc-operatör
    Klubb
    Laholms mfk

    Standard Byron Glasair.

    Hej.
    Någon här med bygg och flyg erfarenheter av en Byron Glasair?
    Det enda man hittar om modellen är att den lätt klipper vid låg fart.
    /Måns

  2. #2
    jocke1963s avatar
    Reg.datum
    dec 2007
    Inlägg
    2 720
    Jobb
    Datanisse
    Klubb
    rcff

    Standard

    Hittade detta på RC-Universe:
    "In the case of the Glasair, sudden and excessive up elevator may cause it to snap roll." "..... until you are comfortable flying the Glasair, you may want to limit up-elevator travel to no more than 3/8" instead of the 1/2" as called for on page five of the assembly instructions."

    O detta på RCGroups:
    "Keep the speed up on final as she likes to snap with that small stab.
    I was always going to sand the out board wing to a flat lifting airfoil to help with that problem."
    ”Vir prudens non contra ventum mingit”

  3. #3


    Reg.datum
    aug 2009
    Inlägg
    11
    Jobb
    Cnc-operatör
    Klubb
    Laholms mfk

    Standard

    Det är ungefär den infon man kan hitta. Lite info som varit bra hade varit hur starka servo man bör köra med, använda ett centralt till skeven eller ett i varje vinge.

Behörigheter för att posta

  • Du får inte posta nya ämnen
  • Du får inte posta svar
  • Du får inte posta bifogade filer
  • Du får inte redigera dina inlägg
  •