Switch 1 0ch 2 off
Follow the steps below to set up your system properly.
1) Turn your transmitter on and switch it to PPM mode. Turn your transmitter off.
2) Turn your transmitter on while holding the F/S button on the transmitter module. Release it in a few seconds. The RED LED on
the transmitter module will flash, indicating the transmitter is ready to bind the receiver.
3) Connect battery to the receiver while holding the F/S button on the receiver. The LED on the receiver will flash, indicating the
binding process is completed.
4) Turn on the transmitter and connect battery to the receiver. The RED LED on the receiver will indicate the receiver is receiving
commands from the transmitter.
After the steps above are completed, both the transmitter and receiver are ready to be used.
https://www.frsky-rc.com/wp-content/...%20Modules.pdf
Precis vad jag har gjort, Uffe......
Funkar INTE!
Retroholic!
https://www.youtube.com/watch?v=75bsCsEkmh0
Kanske kan va till nån hjälp.
Thomas
Ska prova.
Men det är ju lite omständligt att switcharna på sändarmodulen ska stå i olika läge beroende på vilken mottagare som ska bindas.
Lätt att glömma när man skiftar modellminne mellan olika kärror...
Retroholic!
Varför inte ta steget fullt ut, så slipper sådana problem
https://www.rcflight.se/visaprodukt....mbals-kolfiber
I och för sig, men nu trivs jag så bra med min gamla JR 9 II X, så jag tänker hålla den vid liv så länge som jag bara kan...
http://hab-ab.mamutweb.com/subdet22.htm
Retroholic!
Har du kollat vilken mjukvara du har i TX-modul resp. RX?
Tänk även på att inte hålla in F/S-knappen för länge när du slår på sändaren. Då slumpas en ny ”nyckel” fram och alla mottagare får bindas om.
Ove (AM) Nielsen
Tack o lov har det inte hänt.
Ännu....
Retroholic!
Skönt att man inte är ensam....
Retroholic!
Enligt min mening kan man flasha om hur som helst. Man raderar ju programmet i TX/RX och lägger in helt ny programvara. Problemet är att hitta rätt programvara till tätt TX/RX programvara. Kan vara lite knepigt - man får testa de olika varianterna. Börja med den senaste programvaran och gå bakåt i tiden.
Lycka till!
Ove (AM) Nielsen