Hej!
Jag har en Mini Hobby gear & door computer sequencer som jag tänkte använda till min J21R,
Men jag kan inte hitta manualen till den och då kan jag inte programera den.
Är det någon som har manualen till till den och kan hjälpa mig
Hej!
Jag har en Mini Hobby gear & door computer sequencer som jag tänkte använda till min J21R,
Men jag kan inte hitta manualen till den och då kan jag inte programera den.
Är det någon som har manualen till till den och kan hjälpa mig
MVH/Christer
Bättre lite skit i hörnen än ett rent hellvete
Kan det här vara till hjälp?
This device only consumes 30 ma and it's a small package. It uses the gear ATV to set the travel of the gear and doors servos one time, the unit will memorize the data that way gear up and down is only required to initiate the sequence.
Every time you turn on the receiver with the TX on, the unit will initiate the sequence accordingly with the gear selector s/w position and if during the transition the gear s/w is changed, the unit first finishes the cycle then initiates the new command , that way it prevents door and gear miss sequence that some times ends with damaging results.
If you turn on the RX only, the unit will stay in the last position that you previously had set, it means no output to the servos or (MHV) until you turn on the TX.
Hittade det här: http://www.minihobby.com/electronics/mhgdc.htm
/\/\vh // /\/\r J.
Det där har jag också sett men det är bara funktionen på den, inte hur man programerar den,
Tex, landställslucka öppnas-vänta 2 sek-landställ går in-vänta 1sek-landställslucka stängs, typ viggen
eller, landställ går in-vänta 4 sek -landställslucka stängs, typ J21
Tack i alla fall Mr J
MVH/Christer
Bättre lite skit i hörnen än ett rent hellvete
Kontakta tillverkaren/leverantören:
By Phone(954) 746-3094By Mail4851 NW 103rd Ave. Suite #52
Sunrise, FL 33351By Emailminihobby@compuserve.com